Usually, the LED light on a Rockspace extender blinks red due to various reasons. Some of them include an improper power supply, technical glitches, and much more. However, in case the WiFi LED light is flashing specifically, then what will one do? Well, to lay out the answer to this question, we have mentioned some hacks in this article. Once you have troubleshot the issue at hand using them, you will be able to access the re.rockspace.local web address of the Rockspace wireless range extender.

[Fixed] Rockspace Extender WiFi LED Red Issue

1. Check the Ethernet Cable in Use

The primary reason why the WiFi LED light red issue is not letting you enjoy a seamless internet connection on your client device is because the cable that has been put to use for the connection between the devices is not in good condition.
Over time, any cable can get old and this can make it difficult to perform in the same manner as it did when you first started using it. Taking the seriousness of the situation into consideration, you ought to replace the Ethernet cable with a brand-new one. Make sure that you connect it to the ports of the devices and hear the click sound.
The click sound is quite important as it signifies that the cable has been properly connected to the ports. Apart from this, ensure that the connection that you are building at the moment between the networking devices is finger-tight.

2. Change the Location of Extender

Are you reading this section? Well then, we are assuming that the WiFi LED light red issue is still troubling you and not letting you access the internet. No problem. To troubleshoot the issue, another attempt that you can make is to change the location of your extender.
The reason being, it is placed near devices that are interfering with the signals emitted from it. It could be televisions, cordless phones, or refrigerators for that matter. Regardless of the electronic devices that are kept near the extender, relocating it is the only solution in this case. Cannot believe us? Make the required changes and see for yourself.
For your information, mirrors and fish tanks are examples of reflexive surfaces which are also not good for the health of your devices as the signals can bounce off of them. To put an end to this once and for all, you should not keep the extender near them too.

3. Restart the Rockspace Extender

Considering you are still trying to make amends with the Rockspace extender WiFi LED light red issue, then you ought to get rid of technical glitches, which is the third reason why you are here. There are two ways in which you can get rid of them.
First is by restarting your extender and another is by setting it up from scratch. You can set up your device by using the manual method. You will find the instructions to set up both devices in the manual. So, if you are wondering how to setup Rockspace WiFi extender, you already are aware of where you will get the best assistance.
Not just the process of setup, login, or firmware update, but you will find the information related to your extender in the user manual. In case the steps given them seem a little hard for you to understand, then you may refer to the official website of Rockspace.

Summing Up

The last solution is ending the article written on various troubleshooting tips through which the Rockspace extender WiFi LED light red issue can be resolved. In spite of reading the solutions mentioned in this article, if you are still losing your mind because of the same issue, you can restore the device. Now, the actual question is how the process can be gone about. Well, the process is quite easy. You can walk through the steps in the manual or locate and press the reset button, but not with bare hands.

By Admin

Leave a Reply

Your email address will not be published. Required fields are marked *